Enabling the rgu, Enabling the rgu -6 – Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) User Manual
Page 90
Publication 2364F-5.01– October 2003
8-6
Setting Up Your RGU
Enabling the RGU
After the basic startup procedure has been completed, the RGU can
be enabled. The RGU can be enabled by three different methods.
1. Send an enable command to the Host Command Word by setting
the Enable Cmd bit (P32 bit 1 = 1).
2. If the Remote/Local Selector has been set to Local Only (P8=0),
reset the RGU. The unit will automatically enable after the reset.
3. If the Remote/Local Selector has been set to Remote+Local
(P8=1), press the green start key on a HIM, GPT, or DrivePanel
(DriveTools). Note that P224 and P225 must be configured
appropriately for this.
SCANport Port Enable Mask [P224]
Verify that the appropriate SCANport ports are active. Note the following bits:
SCANport 1 (bit 1)
Activates J10 on the main control board (used for HIM, GPT, etc. connection).
SCANport 2 (bit 2)
Activates J9 on the main control board (used for HIM, GPT, etc. connection).
SCANport 6 (bit 6)
Activates J8 on the main control board (used for optional SCANport interface board).
SCANport Enable Mask [P225]
This setting determines if the start key on a connected SCANport device can be used to enable the RGU.
Verify that the appropriate bits are set to 1.
Note: P5 (Remote/Local Selector) and P224 (SCANport Port Enable Mask) must be set accordingly if
a programming terminal/SCANport device will be used to enable the RGU.
SCANport Clear Fault Mask [P226]
This setting determines which SCANport ports (i.e. J8, J9, or J10) can be used to clear faults in the RGU.
Verify that the desired bits are set to 1. P224 (SCANport Port Enable Mask) must be set accordingly.
SCANport Reset Mask [P227]
This setting determines which SCANport ports (i.e. J8, J9, or J10) can be used to reset the RGU. Verify that
the desired bits are set to 1. P224 (SCANport Port Enable Mask) must be set accordingly.
x 1 1 1 1 1 1 1
P o r t
E n a b l e
M a s k
x 1 1 1 1 1 1 1
E n a b l e
M a s k
x 1 1 1 1 1 1 1
C l e a r
F a u l t
M a s k
x 1 1 1 1 1 1 1
R e s e t
U n i t
M a s k