Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 40)

Publication 2364F-5.01– October 2003
1-24 Overview
Packaging Options
• A door-mounted, ground-fault detection meter-relay
• A door-mounted, fault-clear pushbutton
• A single-phase 115V AC, 15A duplex receptacle
Note: Customer supplies single-phase, 115V AC power and
wiring to the duplex receptacle.
• An audio phone jack
• Tin-plated control bus mounted in rear of cabinet above the power
bus
Note: Control bus is included as part of the control power source
upgrade option.
• Gasketed unit door areas and door-fan filters
• Brady Datab wire labels offering the added protection of a clear
plastic cover on top of the labels
Note: Units come standard with cloth wire labels
• Door mounted HIM (programmer only) or a door-mounted
SCANport connector
Communication Options
• 14G1 board for connecting to Remote I/O
• 14G2 board for connecting to RS232/422/483 (using DF1
protocol) and DH485
• 14G5 board for connecting to Device Net
Year 2000 Ready The RGU is Year 2000 Ready. When the RGU is interfaced with
hardware, firmware, and software that will properly exchange
unambiguous data and that will not impede the performance of the
RGU, the RGU will function consistently without interruption for all
valid dates, and will recognize the year 2000 as a leap year. See the
Allen-Bradley website, www.ab.com, for further details.