Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 209)

Publication 2364F-5.01– October 2003
Programming Parameters D-65
407
Signal Processor 2 Input
[SigProc 2 Input]
This parameter indicates the parameter that is to
be processed through Signal Processor 2.
Parameter Type Sink (Read/Write)
Display Units Parameter Number
Drive Units Display Units * 1
Factory Default 0 (no selection)
Minimum Value 0
Maximum Value Maximum Defined Parameter Number
Related Parameters P408 to P411 (See also P402)
408
Signal Processor 2 Output
[SigProc 2 Output]
This parameter specifies where the results of the
processed value should be placed.
Parameter Type Source (Read Only)
Display Units Parameter Number
Drive Units Display Units * 1
Factory Default 0
Minimum Value 0
Maximum Value Maximum Defined Parameter Number
Related Parameters P407 to P411
409
Signal Processor 2 Gain
[SigProc 2 Gain]
This parameter specifies the gain that should be
applied to the source value (indicated in P407).
Note that the offset is applied before the gain.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 1.00
Minimum Value -4.00
Maximum Value 4.00
Related Parameters P407 to P411
410
Signal Processor 2 Offset
[SigProc 2 Offset]
This parameter specifies the offset to apply to the
source value (indicated in P407).
Note that the offset is applied before the gain.
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0
Minimum Value -32768
Maximum Value 32767
Related Parameters P407 to P411
411
Signal Processor 2 Cutoff Frequency
[SigProc 2 Cutoff]
This parameter specifies the cutoff frequency to
be used by the signal processor.
Parameter Type Source (Read Only)
Display Units R/S (rad/sec)
Drive Units Display Units * 1
Factory Default 0
Minimum Value -32768
Maximum Value 32767
Related Parameters P407 to P410
412
Signal Processor 3 Input
[SigProc 3 Input]
This parameter indicates the parameter that is to
be processed through Signal Processor 3.
Parameter Type Sink (Read/Write)
Display Units Parameter Number
Drive Units Display Units * 1
Factory Default 0 (no selection)
Minimum Value 0
Maximum Value Maximum Defined Parameter Number
Related Parameters P413 to P416 (See also P402)
413
Signal Processor 3 Output
[SigProc 3 Output]
This parameter specifies where the results of the
processed value should be placed.
Parameter Type Source (Read Only)
Display Units Parameter Number
Drive Units Display Units * 1
Factory Default 0
Minimum Value 0
Maximum Value Maximum Defined Parameter Number
Related Parameters P412 to P416