Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 71)

Publication 2364F-5.01– October 2003
Chapter
7
Installing Your RGU
This chapter provides the following information for the RGU:
• the mechanical installation procedures for connecting the RGU to
AC input power
• setting up the ground-fault detection option (if supplied)
• RGU installation verifications:
•absence of short circuits
•correct control voltage selection SW1 on isolation board
•correct AC input power connections
• individual power up verifications
• instructions for mechanically connecting your RGU to the lineup
• system test procedures