Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 191)

Publication 2364F-5.01– October 2003
Programming Parameters D-47
240
SCANport Remote Data In: P2
[Rem Data In:P2]
This parameter shows the value that is being
passed into SCANport 2 (J9).
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P224, P225
241
SCANport Remote Data In: P3
[Rem Data In:P3]
This parameter shows the value that is being
passed into SCANport 3 (expansion port).
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P224, P225
242
SCANport Remote Data In: P4
[Rem Data In:P4]
This parameter shows the value that is being
passed into SCANport 4 (expansion port).
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P224, P225
243
SCANport Remote Data In: P5
[Rem Data In:P5]
This parameter shows the value that is being
passed into SCANport 5 (expansion port).
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P224, P225
244
SCANport Remote Data In: P6
[Rem Data In:P6]
This parameter shows the value that is being
passed into SCANport 6 (J7).
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P224, P225
245
SCANport Remote Data Out: P1
[Rem Data Out:P1]
This parameter shows the value that is being
passed through SCANport 1 (J10).
To display a parameter value on the main HIM
screen, link the desired parameter within P245.
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P224, P225
For example, linking P14 to P245 (Measured
AC Line Voltage) would cause a HIM connected
to J10 to display P14 on the main screen.
246
SCANport Remote Data Out: P2
[Rem Data Out:P2]
This parameter shows the value that is being
passed out SCANport 2 (J9).
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 0.00
Minimum Value 0.00
Maximum Value 65535
Related Parameters P224, P225