Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 184)

Publication 2364F-5.01– October 2003
D-40 Programming Parameters
185
Fault/Warning Select Mask 4
[Fault/Warn Mask4]
This parameter determines whether conditions
should be reported as a warning (0) or handled as
a fault (1).
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 0000 0001 0111 1010
Minimum Value 0000 0000 0000 0000
Maximum Value 1111 1111 1111 1111
Related Parameters P183, P184
Bit Description
0 I2t Warnings Selects response to warnings detected by the I2t wire overload protect circuit.
1* I2t Overload Selects response to overload conditions detected by the I2t wire overload protect circuit.
2 H/S HighTemp Selects response when the RGU heatsink temperature is high (P87).
3* Reset Req’d Selects response to reset required conditions (P32).
4 NTC Open Selects response to NTC open condition.
5 NTC Short Selects response to NTC short condition.
6* MSTR Faulted Selects response when the master RGU faults (see P20).
7 1 Phase Warn Selects response when single phase condition has been detected (see P147).
8 1 Phase Err Selects response when single phase condition has persisted beyond time limit (see P148).
9-15 Not Used
* These items cannot be changed to zero.
186-188
P186-P188 are for internal use only.
189
Auxiliary Relay Source
[Aux Relay Ind]
This parameter specifies the source to be used in
the logic operation shown in P191. This source
parameter will be masked with the value in P190
to determine if the auxiliary relay will change state.
Parameter Type Sink (Read/Write)
Display Units Parameter Number
Drive Units Display Units * 1
Factory Default 33 (Host Status Word 1)
Minimum Value 0 (disabled)
Maximum Value Maximum Defined Parameter Number
Related Parameters P190, P191, P192
190
Auxiliary Relay Mask
[Aux Relay Mask]
This parameter defines the mask to be applied to
the value of the Auxiliary Relay Source parameter
(P189).
Press F3 to change the parameter display to
binary, hexadecimal, etc.
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 1
Minimum Value 0
Maximum Value 65535
Related Parameters P189, P191, P192
Bit
8
Bit
9
Bit
10 Bit
11 Bit
12 Bit
13 Bit
14 Bit
15 Bit
0
Bit
1
Bit
2
Bit
3
Bit
4
Bit
5
Bit
6
Bit
7