AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 152)

Chapter 11: Board Configuration
136 MaxCS 7.5 Administration Manual
This dialog box displays the board serial number, top access card serial number, bottom access card serial
number, DSP clock, board ID, physical ID, and logical ID. You can choose to configure the board as either T1
or E1, then click OK. Additional steps are needed to further configure the CAS or PRI protocol in the Protocol
Configuration window, shown in (see Figure
65) and (see Figure 66).
Configuring the Virtual MobileExtSP Board
A simulated physical board – MobileExtSP board – is created in the Softswitch server when you install the
MAXCS system. This single MobileExtSP board handles all mobile extensions.
Configuring the virtual MobileExtSP board is discussed on page 222 in the chapter “Mobile Extension
Configuration.”