AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 423)

MaxCS 7.5 Administration Manual 407
E1 ISDN PRI Installation
This section describes the configuration procedures necessary to implement E1 ISDN PRI signaling for
European, Pacific Rim, and other emerging markets. Please carefully follow the procedures step by step.
1.
Change the Configure Type to E1:
a. From Boards view, double-click the board to be configured to open the Board Configuration
window.
b. In the Board Configuration window, click the Board Configuration button.
c. In the next configuration window, select E1 as the configure type and click OK.
Important: When changing from E1 to T1, then back to E1, channel group properties will be reset to default
values. It is important to make sure the channel group properties are configured properly. Follow
the steps below to re-check your settings for the physical layer and data link layer.
2. In the Board Configuration window, double-click the channel group.
Venezuela / Nacional
MFC-R2
Set calling part category : 1
[Assume no caller ID provided]:
Incoming sequence : DID/DNIS
In-call signaling (depend on how many DID digits):
For 3-digit DID, set to (113)6
For 4-digit DID, set to (1113)6
For 5-digit DID, set to (11113)6
For 6-digit DID, set to (111113)6
For 7-digit DID, set to (1111113)6
For 8-digit DID, set to (11111113)6
[Assume caller ID provided]:
Incoming sequence (same as above shown):
DID/DNIS * Caller ID
In-call signaling (depend on how many DID digits) :
For 3-digit DID, set to (115)*(K)36
For 4-digit DID, set to (1115)*(K)36
For 5-digit DID, set to (11115)*(K)36
For 6-digit DID, set to (111115)*(K)36
For 7-digit DID, set to (1111115)*(K)36
For 8-digit DID, set to (11111115)*(K)36
Country Signaling Values