AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 229)

Configuring the AltiGen IP Phone
MaxCS 7.5 Administration Manual 213
General IP Phone Parameters
The fields in the right part of the window apply to both AltiGen IP phones and to Polycom IP phones.
Default Trunk Access
Code Lets you set the digit required to enable a user to return an outside call from the Call Log.
The default trunk access code can be the route access code, if it is set in MaxAdmin.
Debug
This is for debugging the IP phone using Telnet.
You must enter a Diagnostic password when logging in to MaxAdmin (before you enter
your Admin password) to enable this configuration.
TFTP
Lets you assign the TFTP server to which the IP phone can connect for updating firmware
when necessary. Enter the IP address of the TFTP server in the Server field.
To reset the phone and download the latest firmware image, check the Reset IP Phone
and Boot Download check boxes. If you only check the Boot Download box, the
firmware will be downloaded when the IP phone reboots (power cycles) next time.
Note: Make sure the TFTP server is running and the new firmware image is loaded to
the correct directory before you reset and download firmware.
Network Setting
• TOS (Hex) – Type of Service. 8 bits in the IP header are reserved for the service type.
They can be divided into 5 subfields: The 3 precedence bits have a value from 0 to 7
and are used to indicate the importance of a datagram. Default is 0 (higher is better).
Bits 3 4 5 represent the following:
D: requests low delay
T: requests high throughput
R: requests high reliability
• Enable VLAN – If your network administrator has configured VLAN, check this check
box to enable VLAN for the selected phone. Then enter the VLAN ID for the line port
(voice service) and the VLAN ID for the PC port (data service). (Get these IDs from
your network administrator.) See “Virtual LANs” on page 299 for information on VLANs.
General
Parameter
Description
Time Display
• Offset
– A per phone-based configuration that allows a remote AltiGen or Polycom IP
phone to display a different time, based on location. The offset is the time difference,
in hours, between the AltiGen system and the IP phone.
• Format
– A per-phone-based configuration that allows the AltiGen or Polycom IP
phone to display the time in one of the following formats: 24 hour (example: 13:15), 12
hour AM/PM (example: 1:15 PM), or (on AltiGen IP phones) AM/PM 12 hour (example:
PM 1:15
)
3rd Party SIP
Device
• Enable SIP Telephony Service – Enables SIP hold, SIP transfer, and SIP server-side
conference features for the selected 3rd party IP phone extension.
If the IP phone is SIP-enabled, the Flash key (which includes the Hold button in
MaxAgent/MaxCommunicator) is not supported when you check this setting.
• Enable Polycom Advanced Features – Enables additional features for various mod-
els of Polycom phones. Refer to the MAXCS 7.5 Polycom Configuration Guide for full
details.
This parameter must be enabled for Polycom phones.
AltiGen IP Phone
Parameter
Description