AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 197)

Setting up Extensions
MaxCS 7.5 Administration Manual 181
Physical Location and Type
You can change the extension’s type and location.
Figure 111. Extension Location and Type options
• Type
The type of extension—physical or virtual—is set when you create the extension. After you create the
extension, the type is displayed in brackets in the Agent/Supervisor/Extension list on the left side of the
Extension Configuration window.
You can change a Virtual extension to a Physical one, and vice versa.
If you change the type to physical, you can also set the location and configure the line as discussed in
the “Setting the Line Properties” on page 181.
For information about IP extension configuration, see “Setting Up IP Extensions” on page 203.
• Location
• Assigning a location to a physical extension – When changing a virtual extension to a physical
extension, the Location parameters are available. If you know which board and channel this extension
is wired to, you can use the Prev and Next buttons to select the correct board and channel number for
this physical extension.
• Changing the location – To change the location of a physical extension, select the extension number
in the list of extensions, then click the Prev or Next buttons to change the board and channel settings
until the location you want is displayed. Like other changes, this change isn’t finalized until you click
Apply
.
Setting the Line Properties
For a physical extension, you can configure hardware options on the port used for the extensions. To do so,
select the extension number in the list of extensions, then click the Line Properties button to open a dialog
box that is specific to the board used for the extension.
Triton Analog Station Line Properties
If you select a Triton Analog Station Board extension and click the Line Properties button, you’ll see the Triton
Analog Station Line Properties dialog box.
You can also access this window by double-clicking a span in Channel Mapping List of the Triton Analog
Station Board configuration window.