AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 228)

This panel applies to
both AltiGen and
Polycom IP phones
This panel applies
only to AltiGen IP
phones
Chapter 17: IP Phone Configuration
212 MaxCS 7.5 Administration Manual
Figure 126. IP Phone Configuration General tab
The left side of the IP Phone Configuration window displays all the IP phone extensions that have been set up
in the system. The status "Inactive" means the Enable IP Extension box is checked for this extension in the
Extension Configuration window, but there is no IP phone logged in to the extension. The extension may be a
physical extension using an analog phone, a MobileExt, or a virtual extension.
After creating the IP extensions, you can set the parameters on the General tab.
Note: The Apply To button works with the following parameters: General, TFTP Server field (Reset IP
Phone
and Boot Download options cannot be applied to multiple extensions), Debug, and Display
Workgroup Status (IP 705, IP 805, and IP 600 phones).
AltiGen IP Phone Parameters
The fields in the left part of the window apply only to AltiGen IP phones.
AltiGen IP Phone
Parameter
Description
General Info
Lets you specify the IP address of the MAXCS system the IP phone is connected to. Also
see Configuring Auto-Discovery of Server IP Address on page 216. The version of
firmware associated with the IP phone is automatically displayed in the Version field.
To protect the configuration on the IP phone, check the Enable Protection on Menu
check box and assign a numerical password. When the user presses the Menu button on
the IP phone to access the phone configuration menu, the user will need to enter the
assigned password. You can use this check box for two purposes:
• If you publish the configuration password to the user, only the phone user would be
able to change the phone configuration.
• If you do not publish the configuration password, you can block the phone user from
changing the phone configuration.
To protect only the E911 Location ID assigned to this phone, check the Enable Protection
on E911
checkbox and enter the password that the user must type on the device in order
the change the E911 configuration. See the chapter Location-Based E911 (for Roaming
Users)
on page 291 for instructions on configuration E911 for IP phones.