NXP Semiconductors LPC24XX UM10237 - Manual (Page 341)

UM10237_4 © NXP B.V. 2009. All rights reserved.
User manual Rev. 04 — 26 August 2009 341 of 792
NXP Semiconductors
UM10237
Chapter 13: LPC24XX USB device controller
9.3.3 USB Device Interrupt Enable register (USBDevIntEn - 0xFFE0 C204)
Writing a one to a bit in this register enables the corresponding bit in USBDevIntSt to
generate an interrupt on one of the interrupt lines when set. By default, the interrupt is
routed to the USB_INT_REQ_LP interrupt line. Optionally, either the EP_FAST or FRAME
interrupt may be routed to the USB_INT_REQ_HP interrupt line by changing the value of
USBDevIntPri. USBDevIntEn is a read/write register.
9.3.4 USB Device Interrupt Clear register (USBDevIntClr - 0xFFE0 C208)
Writing one to a bit in this register clears the corresponding bit in USBDevIntSt. Writing a
zero has no effect.
Remark: Before clearing the EP_SLOW or EP_FAST interrupt bits, the corresponding
endpoint interrupts in USBEpIntSt should be cleared.
USBDevIntClr is a write only register.
6 RxENDPKT The current packet in the endpoint buffer is transferred to the CPU. 0
7 TxENDPKT The number of data bytes transferred to the endpoint buffer equals the number of
bytes programmed in the TxPacket length register (USBTxPLen). 0
8 EP_RLZED Endpoints realized. Set when Realize Endpoint register (USBReEp) or MaxPacketSize
register (USBMaxPSize) is updated and the corresponding operation is completed. 0
9 ERR_INT Error Interrupt. Any bus error interrupt from the USB device. Refer to Section 13–11.9
“Read Error Status (Command: 0xFB, Data: read 1 byte)” on page 368
0
31:10 - Reserved, user software should not write ones to reserved bits. The value read from a
reserved bit is not defined. NA
Table 299. USB Device Interrupt Status register (USBDevIntSt - address 0xFFE0 C200) bit description
Bit Symbol Description Reset value
Table 300. USB Device Interrupt Enable register (USBDevIntEn - address 0xFFE0 C204) bit allocation
Reset value: 0x0000 0000
Bit 31 30 29 28 27 26 25 24
Symbol - - - - - - - -
Bit 23 22 21 20 19 18 17 16
Symbol - - - - - - - -
Bit 15 14 13 12 11 10 9 8
Symbol - - - - - - ERR_INT EP_RLZED
Bit 7 6 5 4 3 2 1 0
Symbol TxENDPKT Rx
ENDPKT
CDFULL CCEMPTY DEV_STAT EP_SLOW EP_FAST FRAME
Table 301. USB Device Interrupt Enable register (USBDevIntEn - address 0xFFE0 C204) bit description
Bit Symbol Value Description Reset value
31:0 See
USBDevIntEn
bit allocation
table above 0 No interrupt is generated. 0
1 An interrupt will be generated when the corresponding bit in the Device
Interrupt Status (USBDevIntSt) register (
Table 13–298 ) is set. By default,
the interrupt is routed to the USB_INT_REQ_LP interrupt line. Optionally,
either the EP_FAST or FRAME interrupt may be routed to the
USB_INT_REQ_HP interrupt line by changing the value of USBDevIntPri.