NXP Semiconductors LPC24XX UM10237 - Manual (Page 477)

UM10237_4 © NXP B.V. 2009. All rights reserved.
User manual Rev. 04 — 26 August 2009 477 of 792
NXP Semiconductors
UM10237
Chapter 18: LPC24XX CAN controllers CAN1/2
[1] - Setting the command bits TR and AT simultaneously results in transmitting a message once. No re-transmission will be performed in
case of an error or arbitration lost (single shot transmission).
- Setting the command bits SRR and TR simultaneously results in sending the transmit message once using the self-reception feature.
No re-transmission will be performed in case of an error or arbitration lost.
- Setting the command bits TR, AT and SRR simultaneously results in transmitting a message once as described for TR and AT. The
moment the Transmit Status bit is set within the Status Register, the internal Transmission Request Bit is cleared automatically.
- Setting TR and SRR simultaneously will ignore the set SRR bit.
Table 421. Command Register (CAN1CMR - address 0xE004 4004, CAN2CMR - address 0xE004 8004) bit description
Bit Symbol Value Function Reset
Value RM
Set
0 [1][2] TR Transmission Request. 0 0
0 (absent) No transmission request.
1 (present) The message, previously written to the CANxTFI, CANxTID, and
optionally the CANxTDA and CANxTDB registers, is queued for
transmission from the selected Transmit Buffer. If at two or all three
of STB1, STB2 and STB3 bits are selected when TR=1 is written,
Transmit Buffer will be selected based on the chosen priority
scheme (for details see
Section 18–6.3 “Transmit Buffers (TXB)” )
1 [1][3] AT Abort Transmission. 0 0
0 (no action) Do not abort the transmission.
1 (present) if not already in progress, a pending Transmission Request for the
selected Transmit Buffer is cancelled.
2 [4] RRB Release Receive Buffer. 0 0
0 (no action) Do not release the receive buffer.
1 (released) The information in the Receive Buffer (consisting of CANxRFS,
CANxRID, and if applicable the CANxRDA and CANxRDB registers)
is released, and becomes eligible for replacement by the next
received frame. If the next received frame is not available, writing
this command clears the RBS bit in the Status Register(s).
3 [5] CDO Clear Data Overrun. 0 0
0 (no action) Do not clear the data overrun bit.
1 (clear) The Data Overrun bit in Status Register(s) is cleared.
4 [1][6] SRR Self Reception Request. 0 0
0 (absent) No self reception request.
1 (present) The message, previously written to the CANxTFS, CANxTID, and
optionally the CANxTDA and CANxTDB registers, is queued for
transmission from the selected Transmit Buffer and received
simultaneously. This differs from the TR bit above in that the receiver
is not disabled during the transmission, so that it receives the
message if its Identifier is recognized by the Acceptance Filter.
5 STB1 Select Tx Buffer 1. 0 0
0 (not selected) Tx Buffer 1 is not selected for transmission.
1 (selected) Tx Buffer 1 is selected for transmission.
6 STB2 Select Tx Buffer 2. 0 0
0 (not selected) Tx Buffer 2 is not selected for transmission.
1 (selected) Tx Buffer 2 is selected for transmission.
7 STB3 Select Tx Buffer 3. 0 0
0 (not selected) Tx Buffer 3 is not selected for transmission.
1 (selected) Tx Buffer 3 is selected for transmission.