How to enable realmonitor, 1 adding stacks, 2 irq mode – NXP Semiconductors LPC24XX UM10237 User Manual

Page 751: 3 undef mode, 4 svc mode, Section 35–4 “how to enable realmonitor” on, For det

Advertising
background image

UM10237_4

© NXP B.V. 2009. All rights reserved.

User manual

Rev. 04 — 26 August 2009

751 of 792

NXP Semiconductors

UM10237

Chapter 35: LPC24XX RealMonitor

Undef exception caused by the undefined instructions in user foreground

application. This indicates an error in the application being debugged. RealMonitor
stops the user application until a "Go" packet is received from the host.

When one of these exceptions occur that is not handled by user application, the following
happens:

RealMonitor enters a loop, polling the DCC. If the DCC read buffer is full, control is
passed to rm_ReceiveData() (RealMonitor internal function). If the DCC write buffer is
free, control is passed to rm_TransmitData() (RealMonitor internal function). If there is
nothing else to do, the function returns to the caller. The ordering of the above
comparisons gives reads from the DCC a higher priority than writes to the
communications link.

RealMonitor stops the foreground application. Both IRQs and FIQs continue to be
serviced if they were enabled by the application at the time the foreground application
was stopped.

4.

How to enable RealMonitor

The following steps must be performed to enable RealMonitor. A code example which
implements all the steps can be found at the end of this section.

4.1 Adding stacks

User must ensure that stacks are set up within application for each of the processor
modes used by RealMonitor. For each mode, RealMonitor requires a fixed number of
words of stack space. User must therefore allow sufficient stack space for both
RealMonitor and application.

RealMonitor has the following stack requirements:

4.2 IRQ mode

A stack for this mode is always required. RealMonitor uses two words on entry to its
interrupt handler. These are freed before nested interrupts are enabled.

4.3 Undef mode

A stack for this mode is always required. RealMonitor uses 12 words while processing an
undefined instruction exception.

4.4 SVC mode

RealMonitor makes no use of this stack.

Table 682. RealMonitor stack requirement

Processor mode

RealMonitor Stack Usage (Bytes)

Undef

48

Prefetch Abort

16

Data Abort

16

IRQ

8

Advertising