Texas Instruments MSP430x1xx - Manual (Page 352)

Instruction Set Overview
B-2
B.1 Instruction Set Overview
The following list gives an overview of the instruction set.
Status Bits
V N Z C
* ADC[.W];ADC.B dst dst + C –> dst * * * *
ADD[.W];ADD.B src,dst src + dst –> dst * * * *
ADDC[.W];ADDC.B src,dst src + dst + C –> dst * * * *
AND[.W];AND.B src,dst src .and. dst –> dst 0 * * *
BIC[.W];BIC.B src,dst .not.src .and. dst –> dst – – – –
BIS[.W];BIS.B src,dst src .or. dst –> dst – – – –
BIT[.W];BIT.B src,dst src .and. dst 0 * * *
* BR dst Branch to ....... – – – –
CALL dst PC+2 –> stack, dst –> PC – – – –
* CLR[.W];CLR.B dst Clear destination – – – –
* CLRC Clear carry bit – – – 0
* CLRN Clear negative bit – 0 – –
* CLRZ Clear zero bit – – 0 –
CMP[.W];CMP.B src,dst dst – src * * * *
* DADC[.W];DADC.B dst dst + C –> dst (decimal) * * * *
DADD[.W];DADD.B src,dst src + dst + C –> dst (decimal) * * * *
* DEC[.W];DEC.B dst dst – 1 –> dst * * * *
* DECD[.W];DECD.B dst dst – 2 –> dst * * * *
* DINT Disable interrupt – – – –
* EINT Enable interrupt – – – –
* INC[.W];INC.B dst Increment destination,
dst +1 –> dst
* * * *
* INCD[.W];INCD.B dst Double-Increment destination,
dst+2–>dst
* * * *
* INV[.W];INV.B dst Invert destination * * * *
JC/JHS Label Jump to Label if
Carry-bit is set
– – – –
JEQ/JZ Label Jump to Label if
Zero-bit is set
– – – –
JGE Label Jump to Label if
(N .XOR. V) = 0
– – – –
JL Label Jump to Label if
(N .XOR. V) = 1
– – – –
JMP Label Jump to Label unconditionally – – – –
JN Label Jump to Label if
Negative-bit is set
– – – –
JNC/JLO Label Jump to Label if
Carry-bit is reset
– – – –
JNE/JNZ Label Jump to Label if
Zero-bit is reset
– – – –