Lenze 9400 - Manual (Page 216)

5 Motor interface
5.9 Monitoring
216
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Structure of the I 2 xt monitoring
The introduction of a two-component model with two time constants (one for the winding and the
other for the housing/laminated core) serves to display the thermal behaviour of the motor up to
500% of the rated current:
[5-34] Structure of the motor monitoring
Calculation with only one time constant
With
C01195 = "0 %" the time constant for the winding is not considered and the thermal model is
only calculated with the time constant set for the housing/laminated core.
• The setting C01195 = "0 %" is reasonable if for example the two time constants are not known.
• The calculation simplified due to this setting corresponds to the calculation in the previous
Lenze devices (e.g. 9300 servo inverter or ECS).
 Thermal utilisation of the motor in [%]
k
1
1
(1 + p )
t
1
k
2
1
(1 + p )
t
2
Œ
I
act motor
I
perm motor
(n)
2
Parameter Setting
I
act motor
Actual motor current -
I
perm motor
(n) Permissible motor current (speed-dependent) -
τ
1
Therm. time constant coil C00128/1
k
1
Percentage of the winding in the final temperature C01195
τ
2
Therm. time constant plates C00128/2
k
2
Percentage of the steel plates in the final temperature 100 % - C01195