Index – Lenze 9400 User Manual
Page 946
Index
946
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Motor mounting direction (C02527)
Motor operating temperature (C01194)
Motor parameter identification was cancelled (error message)
Motor phase failure
Motor phase failure monitoring
Motor phase failure threshold (C00599)
Motor phase failure volt. threshold (C02867)
Motor protection
,
Motor reference speed
Motor reference speed (C00011)
Motor rotor resistance (C00082)
Motor rotor time constant (C00083)
Motor speed
Motor standstill time constant (C00494)
Motor stator leakage inductance (C00085)
Motor stator resistance (C00084)
Motor switched off (error message)
Motor temp. feedback system (C01193)
Motor temperature
Module selected in C01193 not available (error message)
Motor temperature (C00063)
Motor temperature monitoring (PTC)
Motor thermal sensor (C01190)
Motor voltage (C00052)
Multiturn resolution (C02761)
MXI1
CAN module is missing or incompatible (error message)
Digital frequency module is missing or incompatible (error
message)
Ethernet module is missing or incompatible (error message)
ICM module is missing or incompatible (error message)
Module changed during operation (error message)
Module has been changed (error message)
Module is defect or missing (error message)
Module is missing or incompatible (error message)
PROFIBUS module is missing or incompatible (error message)
Wrong module (error message)
MXI2
CAN module is missing or incompatible (error message)
Digital frequency module is missing or incompatible (error
message)
Ethernet module is missing or incompatible (error message)
ICM module is missing or incompatible (error message)
Module changed during operation (error message)
Module has been changed (error message)
Module is defect or missing (error message)
Module is missing or incompatible (error message)
PROFIBUS module is missing or incompatible (error message)
Wrong module (error message)
N
Negative direction of rotation limited (error message)
Negative limit switch has triggered (error message)
Negative software limit switch overtravelled (error message)
Network management telegram (NMT)
New application loaded (error message)
NMT (network management)
No heartbeat signal detected (error message)
No parameters for module in MXI1 (error message)
No parameters for module in MXI2 (error message)
No. of CRC cycles (C00618)
Node address
Node guarding event
Node guarding protocol
Node ID
Node life time
Number Of Cam Data Points (C02922)
Number Of Cam Tracks (C02919)
Number Of Cont Data Points (C02942)
Number Of Cont Tracks (C02939)
Number of encoder increments (C00420)
Number of Pos Data Points (C02962)
Number of Pos Tracks (C02959)
O
observation software limit positions (C02720)
Offset actual pos. value/setp. (C02578)
Online change mode
Online Change Mode (C02905)
Online Change State (C02906)
Operating mode (C02770)
Operating mode brake (C02580)
Operation with increased continuous power
Optimising response to setpoint changes
Overcurrent detected (error message)
Overload
P
Parameter error information (C217)
Parameter set
Type of standard device has been changed (error message)
Version conflict (error message)
Parameter set faulty (error message)
Parameter set loaded (error message)
Parameter set restored (error message)
Parameter set saved (error message)
Parameter set switching
Parameter sets
Password entry
Password for cam data
PDO delay