Lenze 9400 - Manual (Page 716)

14 Parameter reference
14.1 Structure of the parameter descriptions
716
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14.1.3.1 Parameters with setting range
Description structure
Parameter setting in the »Engineer«
In the »Engineer«, parameters are set by entering the desired value into the input field:
14.1.3.2 Parameters with selection list
Description structure
Parameter setting in the »Engineer«
In the »Engineer«, a list field is used for parameter setting:
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Setting range
(min. value | unit | max. value) Lenze setting
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Selection list
(Lenze setting printed in bold)
1
2
3
 Read access  Write access  CINH  PLC STOP  No transfer