Lenze 9400 - Manual (Page 719)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
719
14 Parameter reference
14.1 Structure of the parameter descriptions
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14.1.4 Parameter attributes
Description structure
The table footers contain the parameter attributes:
Meaning of the attributes
Scaling factor
The "scaling factor" is important for the parameter access via a bus system:
14.1.5 Abbreviations used in parameter & selection texts
Since the character length of the parameter and selection texts is limited, the following
abbreviations are used:
 Read access  Write access  CINH  PLC STOP  No transfer
Attribute Meaning
 Read access Read access to parameter possible.
 Write access Write access to parameter possible.
• Please also observe the following attributes:
 CINH Parameter value can only be changed when the
controller is inhibited.
 PLC STOP Parameter value can only be changed when the
application is stopped.
 No transfer The parameter is not transferred to the regenerative power supply module when the
command Download parameter set is executed.
Read value (via bus system) Scaling factor Indicated value (Engineer) ⋅ =
Abbreviation Meaning
CAN module CANopen communication module (type E94AYCCA)
ENP Electronic nameplate
Ethernet module Ethernet communication module (type E94AYCEN)
MXI1 Module eXtension Interface 1 - module slot for extension 1
MXI2 Module eXtension Interface 2 - module slot for extension 2