Lenze 9400 - Manual (Page 761)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
761
14 Parameter reference
14.2 Parameter list | C00227
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00227
C00254
C00270
C00271
Parameter | Name:
C00227 | Behaviour due to change of parameter set
Data type: UNSIGNED_32
Index: 24348
d
= 5F1C
h
From software version V5.0
By selecting "1" in the corresponding subcode a module plugged into module slot MXI1 or MXI2 can be excepted
from the parameter set changeover via the device command "Activate parameter set n".
• By this the parameter set changeover, in particular for active modules, is carried out much more quickly.
• An exception from the parameter set changeover for instance is reasonable if different parameter sets are used
(e. g. for different tools within the machine), but if the parameters are always the same for the module (e. g.
communication parameters).
Selection list (Lenze setting printed in bold)
0 Included
1 Excluded
Subcodes Lenze setting Info
C00227/1 0: Included Change of parameter set: MXI1
C00227/2 0: Included Change of parameter set: MXI2
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00254 | Phase controller gain
Data type: UNSIGNED_32
Index: 24321
d
= 5F01
h
Setting range (min. value | unit | max. value) Lenze setting
0.00 1/s 1000.00 20.00 1/s
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00270 | Freq. - current setpoint filter
Data type: UNSIGNED_32
Index: 24305
d
= 5EF1
h
 Set current setpoint filter (band-stop filter)
Setting range (min. value | unit | max. value)
1.0 Hz 1000.0
Subcodes Lenze setting Info
C00270/1 200.0 Hz Freq. - current setp. filter 1
C00270/2 400.0 Hz Freq. - current setp. filter 2
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10
Parameter | Name:
C00271 | Width - current setp. filter
Data type: UNSIGNED_32
Index: 24304
d
= 5EF0
h
 Set current setpoint filter (band-stop filter)
Setting range (min. value | unit | max. value)
0.0 Hz 500.0
Subcodes Lenze setting Info
C00271/1 20.0 Hz Width current setp. filter 1
C00271/2 40.0 Hz Width current setp. filter 2
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10