Canon imagePROGRAF TA-20 MFP 24" Large Format Printer with L24ei Scanner and Stand Kit - Manual (Page 161)

Select whether B4 or 10 inch is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 2
Select whether A3 or 300 mm is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 3
Select whether 300 mm or 12 inch is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 4
Select whether 500 mm or 20 inch is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 5
Select whether B2 or 20 inch is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 6
Select whether A1 or 600 mm is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 7
Select whether 600 mm or 24 inch is applied when a sheet of an intermediate size is detected.
• Auto feed at power on
When Enable is selected, the printer judges the existence of paper exchange when starting up, and if
paper has been exchanged, paper feeding operation is performed.
It may take time to judge paper exchange.
When Disable is selected, the printer does not judge whether or not to change the paper when starting
up, and waits with the current paper feed setting.
• Print advanced paper settings
Tapping Yes prints out each setting specified in Advanced paper settings .
• Reset paper settings for all paper
Tapping Yes initializes each setting specified in Advanced paper settings .
Entering the administrator password is required if it is enabled.
Important
• When you set the paper settings back to the factory default, added or updated paper information
using Media Configuration Tool is erased.
161