Canon imagePROGRAF TA-20 MFP 24" Large Format Printer with L24ei Scanner and Stand Kit - Manual (Page 440)

Firmware update
This setting item is displayed by tapping Device settings after tapping ( Setup ) on the HOME
screen.
Important
• The administrator password is required to change settings if it is enabled for changing settings using
the operation panel.
You can update the firmware of the printer, check the firmware version, or perform settings of a notification
screen, a DNS server and a proxy server.
Note
• If LAN is disabled, you can not use Install update , DNS server setup , Proxy server setup .
• Install update
Performs the firmware update of the printer. If you select Yes , the firmware update starts. Follow the on-
screen instructions to perform update.
Important
• When you use this function, make sure the printer is connected to the Internet.
Note
• If the firmware update is not complete, check the following and take an appropriate action.
• Check the network settings such as a wireless router.
• If Cannot connect to the server. is displayed on the touch screen, select OK and try again
after a while.
• Check current version
You can check the current firmware version.
• Update notification setting
When Yes is selected and the firmware update is available, the screen to inform you of the firmware
update is displayed on the touch screen.
• DNS server setup
Performs settings for a DNS server. Select Auto setup or Manual setup . If you select Manual setup ,
follow the display on the touch screen to perform settings.
• Proxy server setup
Performs settings for a proxy server. Follow the display on the touch screen to perform settings.
440