Canon imagePROGRAF TA-20 MFP 24" Large Format Printer with L24ei Scanner and Stand Kit - Manual (Page 79)

Specifying the Cutting Method for Rolls
How rolls are cut after ejection varies depending on printer settings.
• Automatic cut
The roll is automatically cut by the cutter blade according to the printer driver settings.
◦ Printer Setting
Tap paper settings display area > Paper settings > Advanced > Cutting mode > Automatic cut
◦ Driver Setting
Automatic Cutting > Yes
See " Cutting Roll Paper after Printing " (Windows).
See "Cutting Roll Paper after Printing" (macOS).
• Eject (when the paper surface is being scratched / to wait for ink to dry)
Select this to move the cutter by operation panel operation and cut paper. With Automatic cut , the
paper drops and may rub against the basket, resulting in damage to the print surface, but you can cut
using this method and supporting the paper so that it does not drop to avoid damage to the paper. Also,
you can prevent paper that has not dried from dropping by visually checking the ink has dried, and then
cutting the paper.
After printing, tap Cut paper and cut the roll paper on the cutter blade.
◦ Printer Setting
Tap paper settings display area > Paper settings > Advanced > Cutting mode > Eject cut
◦ Driver Setting
Automatic Cutting > Yes
See " Cutting Roll Paper after Printing " (Windows).
See "Cutting Roll Paper after Printing" (macOS).
• Manual (when using media that cannot be cut with the cutter blade)
Select this if the paper cannot be cut on the cutter blade.
Cut each page from the roll using scissors. For continuous printing (if you will cut each page later),
select
Automatic Cutting > Yes or select Print Cut Guideline .
◦ Printer Setting
Tap paper settings display area > Paper settings > Advanced > Cutting mode > User cut
◦ Driver Setting
Automatic Cutting > No , Yes , Print Cut Guideline
See " Cutting Roll Paper after Printing " (Windows).
See "Cutting Roll Paper after Printing" (macOS).
79