Cut to standard size, Standard cut examples – Canon imagePROGRAF TA-20 MFP 24" Large Format Printer with L24ei Scanner and Stand Kit User Manual
Page 190
Cut to standard size
Specifies standard size as the output page size when printing on roll paper.
This setting item is displayed by tapping in the following order.
(
Setup
) >
Device settings
>
Print settings
>
HP-GL/2 print settings
>
Paper settings
•
ON
Cuts to standard size in accordance with the roll paper width.
When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected
automatically.
Note
• If
ON
is selected for
Conserve paper
and there is blank space above/below the image, the size will
not be standard size.
• When
ON
is selected for
Print centered
, printing will be in the center of the standard size.
• If there is no standard size corresponding to the roll paper width, operation is the same as if
OFF
is
selected. No message is displayed.
• For information about supported standard sizes, see
•
OFF (Initial setting)
Cutting according to standard size is not performed.
STANDARD CUT EXAMPLES
• A3-size width roll paper
A. Position of cut when
OFF
B. Position of cut when
ON
• A3-size width roll paper
190