Canon imagePROGRAF TA-20 MFP 24" Large Format Printer with L24ei Scanner and Stand Kit - Manual (Page 623)

Paper Detailed Settings dialog box
Drying Time
Wait time can be set to allow ink to dry. Between Pages settings are only enabled for roll paper.
Between Pages
The wait time until outputting paper can be set after printing one page. Time is taken before
cutting roll paper to allow the ink to dry, so even when
Automatic Cutting in the Roll Paper
Options of the Page Setup tab is set to Yes , page may be dropped into the basket with dried
ink.
Printer Default
Settings in printer unit control panel are applied.
None
Page will be output immediately after printing
30sec. / 1min. / 3min. / 5min. / 10min. / 30min. / 60min.
Page will be output after set amount of time has passed after printing.
Between Scans
The wait time until printing next scan can be set after printing one scan in page. Set in the event
smudging occurs in the page, unevenness occurs in borderless printing, etc., and you would like
to avoid this smudging and unevenness.
Printer Default
Settings in printer unit control panel are applied.
None
Next scan will be print immediately after first scan is print.
0.5sec. / 1sec. / 3sec. / 5sec. / 7sec. / 9sec.
Next scan will be print after the set amount of time has passed after printing one scan.
* If smudges and/or unevenness occur, please increase time.
Roll Paper Safety Margin
In order for heavily curling paper to absorb well in platen, length of margin established on edge of
paper can be selected.
Near End Margin
Roll Near End Margin length can be set.
Printer Default
Settings in printer unit control panel are applied.
3mm
Will be print in standard size.
* Please select when there are no particular problems with printing.
20mm
Please select when rubbing of the print heads occurs, such as when heavily curling paper is
being used.
Cut Speed
Select auto-cut speed. This can be adjusted when paper cannot be cut precisely with auto-cut.
Printer Default
Settings in printer unit control panel are applied.
623