Canon imagePROGRAF TA-20 MFP 24" Large Format Printer with L24ei Scanner and Stand Kit User Manual
Page 88
Detecting Roll Paper was Replaced While the Power was Off
When you turn the printer on, it can confirm whether the roll paper was replaced while the power was off.
From
Device settings
on the Home screen, set
Auto feed at power on
to
Enable
to detect the position of
the roll paper's leading edge when the power is turned on. If the position of the roll paper's leading edge is
over 1 mm since the last time the power was turned off, the printer determines that the roll paper has been
replaced, and then starts feeding paper automatically to detect the paper width and the barcode for the
management of unused roll paper.
Note
• Setting
Auto feed at power on
to
Enable
causes the operations that can be done after turning on the
power to take longer since the printer must detect the leading edge of the roll paper.
Follow these steps to set
Auto feed at power on
to
Enable
as follows.
1.
Tap
(
Setup
) on Home screen of operation panel.
Note
• If the Home screen does not appear, press the
HOME
button.
2.
Tap
Device settings
.
3.
Tap
Paper-related settings
.
4.
Tap
Auto feed at power on
.
5.
Tap
Enable
.
88