Canon imagePROGRAF TA-20 MFP 24" Large Format Printer with L24ei Scanner and Stand Kit - Manual (Page 562)

6. Complete the setup
Click OK .
When printing is executed, a drapery or banner can be printed according to the roll.
Enlarge and print
1. Register user-defined paper
Register both the actual desired print size (user-defined paper 1) and original document size created
in application (user-defined document size 2) in the
Size Options... under the Page Setup tab.
Note
• Please set user-defined paper 2 to the same aspect ratio as user-defined paper 1. If the aspect
ratio differs, the enlarged image may not turn out to be the expected size.
After creating user-defined paper 1, if user-defined paper 2 is created after checking
Fix the
Ratio of the Width to Height , settings can be set to the same aspect ratio.
Also set user-defined paper 2 to a size that doesn't exceed the maximum size supported by the
application.
For example, when printing on paper 600mm wide and 3,000mm long, use the following
settings.
(when setting length to 1/6 the user-defined paper)
• User-defined paper 1: Width 600mm, Height 3,000mm
• User-defined paper 2: Width 100mm, Height 500mm
2. Create original document in application software
Use registered user-defined paper 2 to create original document in application software.
3. Open printer driver settings screen
4. Select Paper Size
Select registered user-defined paper 1 from Custom Paper Size in Page Setup tab's Page Size .
5. Complete the setup
Click OK .
When you print, the hanging or horizontal banner is printed by using the user-defined size.
Note
• Maximum printable length is 18.0m. In the event the enlarged length exceeds 18.0m, the part of the
image exceeding the length will not be printed.
• If printing cannot be performed correctly, you may be able to improve printing by using Special
Settings on the Layout tab to change FineZoom Settings to Yes .
562