Rockwell Automation 1398-DDM-xxx USE MNL/ULTRA 200 DIG.SERVO.DR - Manual (Page 157)

Publication 1398-5.0 – October 1998
Application and Configuration Examples 8-33
8Application and Configuration Examples
Registration Indexing
The ULTRA 200 Series drive can be set up as a registration indexer by
making the hardware connections and performing the software setup
and tuning described below. A connection diagram depicts the
minimum hardware necessary. Interfacing the drive to an external
controller requires similar circuitry from the controller to J1, refer to
“J1 – Controller” on page 6-1. Instructions are provided to configure
the drive using a PC with ULTRA Master software, but the optional
TouchPad also may be used.
The following example depicts a batched (multiple) move using
registration indexing.
Note: This feature is available only on drives capable of indexing:
1398-DDM-010X, 1398-DDM-020X, 1398-DDM-030X, 1398-DDM-
075X and 1398-DDM-150X.
Figure 8.8 Registration Indexing Examples
Intro
Velocity
Registration Distance
Dwell
Defined
Deceleration Defined
Acceleration
Defined Velocity
Executing
Index Distance Registration
Sensor Detected
Outputs
In Motion
In Dwell
Registered