Rockwell Automation 1398-DDM-xxx USE MNL/ULTRA 200 DIG.SERVO.DR - Manual (Page 39)

Publication 1398-5.0 – October 1998
Chapter 3
ULTRA Master Installation
Chapter 3
Installation of ULTRA Master on a PC is covered in this chapter,
which:
●
Lists the minimum PC hardware and software necessary to run
ULTRA Master.
●
Provides step-by-step instructions on how to load ULTRA Master.
●
Shows you how to start and quit ULTRA Master and introduces
the Drive Window,
the main command window for ULTRA Master.
●
Instructs you on how to access on-line help.
Instructions for using the features available in ULTRA Master are
detailed in on-line help. To access the Help menu, depress the
F1 key.
Hardware and Software
Requirements
The minimum personal computer (PC) requirements to run the
software are:
●
A DOS computer with a 286 microprocessor
●
A hard disk, with 2.0 MB of free disk space
●
3½ inch, 1.44MB floppy disk drive
●
2 MB of RAM
●
A Video Graphics Array (VGA) monitor
●
Microsoft Windows version 3.1
●
A mouse is recommended.
Windows must be installed on your PC. If Windows is not already
installed, refer to the appropriate Microsoft manual to install Windows
on your computer.