Rockwell Automation 1398-DDM-xxx USE MNL/ULTRA 200 DIG.SERVO.DR - Manual (Page 42)

Publication 1398-5.0 – October 1998
3-4 ULTRA Master Installation
From the C:> Prompt
1. Type win c:\ultramst\ultramst.exe.
The ULTRA Master start-up screen will open.
From Windows
1. Choose the ULTRA Master program group from the Program
Manager in Windows.
2. Choose the ULTRA Master icon from the ULTRA Master pro-
gram group.
The ULTRA Master start-up screen will open.
The readme File
A file, titled README, may be included in the ULTRA Master
directory. This file contains installation instructions, change notes
from previous revisions, and information that became available after
this manual was printed. After you install ULTRA Master you can
access this file by choosing the Read Me icon in the ULTRA Master
window or by using Microsoft Write or an equivalent application
program to view the file
readme.wri in the directory path where
ULTRA Master is installed.
Firmware Files
Firmware files are supplied in the Miscellaneous directory on the
ULTRA Master diskette.
The current revision level of drive firmware, excluding the TouchPad
firmware, is displayed in the Drive Information window of
ULTRA Master. The current revision level of TouchPad firmware is
displayed as part of the TouchPad initialization when a TouchPad is
connected to the drive.
The types of files and their functions are:
●
Firmware – Main Operating firmware for the drive
●
Boot Block – Drive Initialization firmware for the drive
Note: This step assumes that ULTRA Master was loaded into the
c:\ultramst directory during setup.
Note: If the ULTRA Master window is not active, hold down ALT and
press TAB (ALT+TAB) until the ULTRA Master title bar and icon are
highlighted, or select ULTRA Master from the list in the Window menu.