Free straight line programming – HEIDENHAIN TNC 620 (81760x-02) ISO programming User Manual
Page 239
Path contours – FK free contour programming (option 19)
6.6
6
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
239
Free straight line programming
Straight line without tangential connection
To display the soft keys for free contour
programming, press the
FK key
To initiate the dialog for free programming of
straight lines, press the
FL soft key. The TNC
displays additional soft keys
Enter all known data in the block by using
these soft keys. The FK graphic displays the
programmed contour element in red until
sufficient data is entered. If the entered data
describes several solutions, the graphic will
display the contour element in green (see "FK
programming graphics", page 237)
Straight line with tangential connection
If the straight line connects tangentially to another contour
element, initiate the dialog with the soft key:
To display the soft keys for free contour
programming, press the
FK key
To initiate the dialog, press the
FLT soft key
Enter all known data in the block by using the soft
keys