7 using 3-d touch probes (option 17), Overview, Ed ("using 3-d touch probes (option 17) – HEIDENHAIN TNC 620 (81760x-02) ISO programming User Manual
Page 461: Using 3-d touch probes (option 17)
Using 3-D touch probes (option 17) 14.7
14
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
461
14.7
Using 3-D touch probes (option 17)
Overview
The following touch probe cycles are available in the
Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Soft key
Function
Page
Calibrating the 3-D touch probe
Measuring a 3-D basic rotation by
probing a plane
Measuring a basic rotation using
a line
Setting a datum in any axis
Setting a corner as datum
Setting a circle center as datum
Setting the centerline as datum
Touch probe system data
management
See User’s
Manual for
Cycles
For more information about the touch probe table,
refer to the User’s Manual for Cycle Programming.