HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 540)

MOD functions
17.8 Software numbers
17
540
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
17.8 Software numbers
Application
The following software numbers are displayed on the TNC screen
after the "Software version" MOD function has been selected:
Control model: Designation of the control (managed by
HEIDENHAIN)
NC SW: Number of the NC software (managed by
HEIDENHAIN)
NCK: Number of the NC software (managed by
HEIDENHAIN)
PLC SW: Number and name of the PLC software (managed
by your machine tool builder)
In the "FCL information" MOD function, the TNC shows the
following information:
Development level (FCL=Feature Content Level):
Development level of the software installed on the control, see
"Feature Content Level (upgrade functions)", page 11
17.9 Entering the code number
Application
The TNC requires a code number for the following functions:
Function Code number
Selecting user parameters 123
Configuring an Ethernet card NET123
Enabling special functions for Q parameter
programming
555343