HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 606)

Tables and overviews
18.5 Functions of the TNC 620 and the iTNC 530 compared
18
606
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
Function TNC 620 iTNC 530
Datum table:
Sorting function by values
within an axis
Available Not available
Resetting the table Available Not available
Hiding axes that are not
present
Available Available
Switching the list/form view Switchover via split-screen key Switchover by toggle soft key
Inserting individual line Allowed everywhere,
renumbering possible after
request. Empty line is inserted,
must be filled with zeros
manually
Only allowed at end of table.
Line with value 0 in all columns
is inserted
Transfer of actual position
values in individual axis to the
datum table per keystroke
Not available Available
Transfer of actual position
values in all active axes to the
datum table per keystroke
Not available Available
Using a key to capture the last
positions measured by TS
Not available Available
FK free contour programming:
Programming of parallel axes With X/Y coordinates,
independent of machine type;
switchover with
FUNCTION
PARAXMODE
Machine-dependent with the
existing parallel axes
Automatic correction of relative
references
Relative references in contour
subprograms are not corrected
automatically
All relative references are
corrected automatically