HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 570)

Tables and overviews
18.1 Machine-specific user parameters
18
570
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
Parameter settings
ChannelSettings
CH_NC
Active kinematics
Kinematics to be activated
List of machine kinematics
Kinematics to be activated with control start-up
List of machine kinematics
Determining the behavior of the NC program
Resetting the machining time with program start
True: Machining time is reset
False: Machining time is not reset
PLC signal for number of pending machining cycle
Dependent on machine builder
Geometry tolerances
Permissible deviation of circle radius
0.0001 to 0.016 [mm]: Permissible deviation of circle radius on the circle end point
compared to circle start point
Configuration of machining cycles
Overlap factor for pocket milling
0.001 to 1.414: Overlap factor for Cycle 4 POCKET MILLING and Cycle 5 CIRCULAR
POCKET
Behavior after machining a contour pocket
PosBeforeMachining: Position as before machining a cycle
ToolAxClearanceHeight: Position tool axis to clearance height
Display "Spindle ?" error message if M3/M4 is not active
on: Output error message
off: Do not output error message
Display "Enter negative depth" error message
on: Output error message
off: Do not output error message
Approach behavior on a slot wall in a cylindrical surface
LineNormal: Approach with straight line
CircleTangential: Approach with an arc movement
M function for spindle orientation in machining cycles
-1: Spindle orientation directly via NC
0: Function inactive
1 to 999: Number of M function for spindle orientation
Do not display "Plunging type not possible" error message
on: Error message is not displayed