Protecting and erasing programs in $mdi – HEIDENHAIN TNC 620 (81760x-02) ISO programming User Manual
Page 499
Advertising
Programming and executing simple machining operations 15.1
15
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
499
Protecting and erasing programs in $MDI
The $MDI file is generally intended for short programs that are
only needed temporarily. Nevertheless, you can store a program, if
necessary, by proceeding as described below:
Select the
Programming mode of operation
To call the file manager, press the
PGM MGT key.
Move the highlight to the
$MD file
Copy a file: Press the
COPY soft key
DESTINATION FILE =
Enter the name under which you want to save the current
contents of the $MDI file, e.g.
BORE.
Press the
OK soft key
Close the file manager:
END soft key
For more information: see "Copying a single file", page 115.
Advertising