HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 481)

Datum setting with 3-D touch probe (option 17) 14.10
14
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
481
14.10 Datum setting with 3-D touch probe
(option 17)
Overview
The following soft-key functions are available for setting the datum
on an aligned workpiece:
Soft key Function Page
Datum setting in any axis with 481
Setting a corner as datum 482
Setting a circle center as datum 483
Center line as datum
Setting the center line as datum 485
Datum setting in any axis
Select the probing function: Press the PROBING
POS soft key
Move the touch probe to a position near the touch
point
Use the soft keys to select the probe axis and
direction in which you want to set the preset, such
as Z in direction Z–
Start the probing procedure: Press the machine
START button
Datum: Enter the nominal coordinate and confirm
your entry with the
SET DATUM soft key, see
"Writing measured values from the touch probe
cycles in a datum table", page 466
To terminate the probe function, press the
END
soft key
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.