Overview: display modes – HEIDENHAIN TNC 620 (81760x-02) ISO programming User Manual
Page 504
Advertising
Test run and program run
16.1 Graphics (option 20)
16
504
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
Overview: Display modes
In the
Program Run, Single Block and Program Run, Full
Sequence operating modes as well as in the Test Run operating
mode, the TNC displays the following soft keys:
Soft key
View
Plan view
Projection in three planes
3-D view
The position of the soft keys depends on the
selected operating mode.
The
Test Run operating mode additionally offers the following
views:
Soft key
View
Volume view
Volume view and tool paths
Tool paths
Limitations during program run
The result of the simulation can be faulty if the TNC's
computer is overloaded with complicated processing
tasks.
Advertising