HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 604)

Tables and overviews
18.5 Functions of the TNC 620 and the iTNC 530 compared
18
604
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
Cycle TNC 620 iTNC 530
410, datum from inside of rectangle X, option 17 X
411, datum from outside of rectangle X, option 17 X
412, datum from inside of circle X, option 17 X
413, datum from outside of circle X, option 17 X
414, datum at outside corner X, option 17 X
415, datum at inside corner X, option 17 X
416, datum at circle center X, option 17 X
417, datum in touch probe axis X, option 17 X
418, datum at center of 4 holes X, option 17 X
419, datum in one axis X, option 17 X
420, measuring an angle X, option 17 X
421, measuring a hole X, option 17 X
422, measuring a circle from outside X, option 17 X
423, measuring a rectangle from inside X, option 17 X
424, measuring a rectangle from outside X, option 17 X
425, measuring inside width X, option 17 X
426, measuring a ridge from outside X, option 17 X
427, boring X, option 17 X
430, measuring a bolt hole circle X, option 17 X
431, measuring a plane X, option 17 X
440, measuring an axis shift – X
441, Rapid probing (on TNC 620 partly possible with touch probe
table)
– X
450, saving the kinematics X, option 48 X, option 48
451, measuring the kinematics X, option 48 X, option 48
452, preset compensation X, option 48 X, option 48
460, calibrating a TS on a sphere X, option 17 X
461, calibrate TS length X, option 17 X
462, calibration in a ring X, option 17 X
463, calibration on stud X, option 17 X
480, calibrating a TT X, option 17 X
481, measuring/inspecting the tool length X, option 17 X
482, measuring/inspecting the tool radius X, option 17 X
483, measuring/inspecting the tool length and radius X, option 17 X
484, calibrating the infrared TT X, option 17 X