HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 407)

The PLANE function: Tilting the working plane (software option 8) 12.2
12
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
407
Specifying the positioning behavior of the PLANE
function
Overview
Independently of which PLANE function you use to define the tilted
machining plane, the following functions are always available for
the positioning behavior:
Automatic positioning
Selection of alternate tilting possibilities (not with
PLANE AXIAL)
Selection of the type of transformation (not with PLANE AXIAL)
Danger of collision!
If you work with Cycle 28 MIRROR IMAGE in a tilted
system, please note the following
Program the tilting motion first and then define Cycle
28 MIRROR IMAGE:
Mirroring a rotary axis with Cycle
28 only mirrors the
motions of the axis, but not the angles defined in the
PLANE functions. As a result, the positioning of the
axes changes.
Programs created on an iTNC 530 or on earlier TNCs
are not compatible.
Automatic positioning: MOVE/TURN/STAY (entry is
mandatory)
After you have entered all parameters for the plane definition,
you must specify how the rotary axes will be positioned to the
calculated axis values:
The PLANE function is to automatically position
the rotary axes to the calculated position values.
The position of the tool relative to the workpiece
is to remain the same. The TNC carries out a
compensation movement in the linear axes
The PLANE function is to automatically position
the rotary axes to the calculated position values,
but only the rotary axes are positioned. The TNC
does not carry out a compensation movement in
the linear axes
You will position the rotary axes later in a separate
positioning block
If you have selected the MOVE option (PLANE function is to position
the axes automatically), the following two parameters must still be
defined:
Dist. tool tip – center of rot. and Feed rate? F=.
If you have selected the TURN option (PLANE function is to position
the axes automatically without any compensating movement), the
following parameter must still be defined:
Feed rate? F=.
If you use PLANE together with STAY, you have to
position the rotary axes in a separate block after the
PLANE function.