8 optional program-run interruption, Application – HEIDENHAIN TNC 620 (81760x-02) ISO programming User Manual
Page 530
Advertising
Test run and program run
16.8 Optional program-run interruption
16
530
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
16.8
Optional program-run interruption
Application
The behavior of this function varies depending on the
respective machine.
Refer to your machine manual.
The TNC optionally interrupts program run at blocks containing M1.
If you use M1 in the Program Run mode, the TNC does not switch
off the spindle or coolant.
Do not interrupt program run or test run at blocks
containing M1: Set soft key to
OFF
Interrupt program run or test run at blocks
containing M1: Set soft key to
ON
Advertising