HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 58)

First steps with the TNC 620
1.4 Graphically testing the first part (Advanced Graphic Features
software option)
1
58
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
1.4 Graphically testing the first part
(Advanced Graphic Features software
option)
Selecting the correct operating mode
You can test programs in the Test Run mode:
Press the Test Run operating mode key: the TNC
switches to that mode
Further information on this topic
Operating modes of the TNC: see "Modes of operation",
page 71
Testing programs: see "Test run", page 514
Selecting the tool table for the test run
You only need to execute this step if you have not activated a tool
table in the
Test Run mode.
Press the PGM MGT key: The TNC opens the file
manager
Press the SELECT TYPE soft key: The TNC shows
a soft-key menu for selection of the file type to be
displayed
Press the
DEFAULT soft key: The TNC shows all
saved files in the right window
Move the highlight to the left onto the directories
Move the highlight to the TNC:\table directory
Move the highlight to the right onto the files
Move the highlight to the file TOOL.T (active tool
table) and load with the ENT key: TOOL.T receives
the status
S and is therefore active for the test run
Press the END key: Exit the file manager
Further information on this topic
Tool management: see "Enter tool data into the table",
page 168
Testing programs: see "Test run", page 514