HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 433)

Moving the machine axes 14.2
14
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
433
14.2 Moving the machine axes
Note
Traversing with the machine axis direction buttons
can vary depending on the machine tool. Refer to
your machine manual.
Moving the axis with the machine axis direction
buttons
Select the Manual Operation mode
Press the machine axis direction button and hold it
as long as you wish the axis to move, or
Move the axis continuously: Press and hold the
machine axis direction button, then press the
machine START button
Stop the axis: Press the machine STOP button
You can move several axes at a time with these two methods. The
control then shows the feed rate. You can change the feed rate
at which the axes are traversed with the
F soft key, see "Spindle
speed S, feed rate F and miscellaneous function M", page 445.
If a traverse task is active on the machine, the control displays the
control-in-operation symbol.