HEIDENHAIN TNC 620 (81760x-02) ISO programming - Manual (Page 588)

Tables and overviews
18.4 Overview tables
18
588
TNC 620 | User's ManualDIN/ISO Programming | 2/2015
M Effect Effective at block... Start End Page
M92
Within the positioning block: Coordinates are referenced to position
defined by machine tool builder, such as tool change position
■ 352
M94
Reduce the rotary axis display to a value below 360° ■ 416
M97 Machine small contour steps ■ 355
M98 Machine open contours completely ■ 356
M99
Blockwise cycle call ■ Cycles
Manual
M101
M102
Automatic tool change with replacement tool if maximum tool life has
expired
Reset M101
■
■
182
M107
M108
Suppress error message for replacement tools with oversize
Reset M107
■
■
182
M109
M110
M111
Constant contouring speed at cutting edge (feed rate increase and
reduction)
Constant contouring speed at cutting edge (only feed rate reduction)
Reset M109/M110
■
■
■
359
M116
M117
Feed rate in mm/min on rotary axes
Reset M116
■
■
414
M118 Superimpose handwheel positioning during program run ■ 362
M120
Pre-calculate the radius-compensated contour (LOOK AHEAD) ■ 360
M126
M127
Shorter-path traverse of rotary axes:
Reset M126
■
■
415
M128
M129
Maintaining the position of the tool tip when positioning with tilted axes
(TCPM)
Reset M128
■
■
417
M130
Within the positioning block: Points are referenced to the untilted
coordinate system
■ 354
M138
Selection of tilted axes ■ 420
M140 Retraction from the contour in the tool-axis direction ■ 364
M143 Delete basic rotation ■ 366
M144
M145
Compensating the machine’s kinematic configuration for ACTUAL/
NOMINAL positions at end of block
Reset M144
■
■
421
M141
Suppress touch probe monitoring ■ 365
M148
M149
Automatically retract tool from the contour at an NC stop
Reset M148
■
■
367