1 connecting the absolute encoder, 1) using an encoder cable with a battery case, 46 and 64 – Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - MECHATROLINK-II Communications Reference User Manual
Page 122
4.7 Absolute Encoders
4-37
4
Ope
rat
ion
4.7.1 Connecting the Absolute Encoder
The following diagram shows the connection between a servomotor with an absolute encoder, the SERVO-
PACK, and the host controller.
(1) Using an Encoder Cable with a Battery Case
∗1. The absolute encoder pin numbers for the connector wiring depend on the servomotors.
∗2.
: represents shielded twisted-pair wires.
∗3. When using an absolute encoder, provide power by installing an encoder cable with a JUSP-BA01-E Battery Case or
install a battery on the host controller.
/PCO
ENC
3
4
CN2
17
18
19
20
21
22
CN1
SG
16
PAO
/PAO
PBO
/PBO
PCO
Absolute encoder
(Shell)
Battery*3
SERVOPACK
Phase A
Phase B
Phase C
Connector
shell
Connector
shell
*2
*2
*1
0 V
Host controller
5
6
1
2
PG5 V
PG0 V
PS
/PS
BAT(+)
BAT(-)
Phase A
Phase B
Phase C
R
R
R
Applicable line receiver: SN75ALS175
or MC3486 manufactured by Texas
Instruments or the equivalent
Terminating resistance R: 220 to 470
Ω
Encoder cable
with battery case
SN75ALS174 output line
driver manufactured by
Texas Instruments or the
equivalent
46 and
64