KORG PA4X 76 - Manual (Page 29)

Setting up the pedals and audio connections |25
Connecting the EC5 multiswitch
Use the EC5 connector to connect the (optional) KORG EC5 multiswitch.
With this programmable controller you can control various functions.
By default, the first switch acts as an automatic accompaniment’s Start/Stop
command, while each of the remaining four switches select one of the four
Style Variations. If you want to change the assigned functions, go to the
Global > Controllers > EC5 page.
Connecting the headphones
Connect a pair of headphones to the PHONES connector. You can use head-
phones with an impedance of 16-200 Ohms (50 Ohms suggested). When con-
necting the headphones, the PaAS speakers are automatically deactivated.
Adjust the output level with the
MASTER VOLUME knob.
Connecting the audio outputs
Use the AUDIO OUTPUT connectors to send the audio output to a mixer, a
set of powered monitors, or an audio amplification system. These are bal-
anced/unbalanced (TRS) 6.35 mm, or 1/4”, jack connectors.
When using a home audio amplifier, connect the other end of the cable to the
CD, LINE IN or TAPE/AUX input of your audio system. Don’t use the PHONO
inputs of your audio system!
▪ Use the LEFT and RIGHT connectors as the main stereo outputs. Connect
either of them to output a mono signal. Adjust the output level with the
MASTER VOLUME knob.
▪ Use the 1 and 2 connectors as the separate sub-outputs. These can be used
for a stereo sub-mix, or to output just a single Sound to be mixed alone, or to
be processed or amplified externally. The Sounds are sent to these outputs
with no effects. Adjust their volume with the mixer’s or external speaker’s
level controls.
If installed, the (optional)
PaAS amplification system will work in parallel
with the main audio outputs.