KORG PA4X 76 - Manual (Page 687)

Effect parameters |683
d MIDI Sync Off, On When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300
sets the tempo manually for this individ-
ual effect
Base Note
…
Selects the type of notes that specify the
LFO speed
Times x1…x32 Sets the number of notes that specify the
LFO speed
e Depth 0…100 Sets the depth of the sampling frequency
LFO modulation
Src Off…Tempo Selects the LFO modulation source of the
sampling frequency
Amt –100…+100 Sets the LFO modulation amount of the
sampling frequency
f Resolution 4…24 Sets the data bit length
g Output Level 0…100 Sets the output level
Src Off…Tempo Selects the modulation source for the
output level
Amt –100…+100 Sets the modulation amount of the out-
put level
h Wet/Dry Dry, 1:99…99:1,
Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Pre LPF
If a sampler with a very low sampling frequency receives very high-pitched
sound that could not be heard during playback, it could generate pitch noise
that is unrelated to the original sound. Set “Pre LPF” to On to prevent this
noise from being generated.
If you set the “Sampling Freq” to about 3 kHz and set “Pre LPF” to Off, you
can create a sound like a ring modulator.
f: Resolution
g: Output Level
If you set a smaller value for the “Resolution” parameter, the sound may
be distorted. The volume level may also be changed. Use “Output Level” to
adjust the level.