KORG PA4X 76 - Manual (Page 433)

Editing the Sounds |429
Programming the amplitude envelope (amp EG)
You can create time-varying changes in the volume of the selected oscillator.
▪ Go to the Sound > Amp > EG page.
The diagram on top of the page shows the Amplitude envelope line.
Setting the Amp EG levels and times
Amp EG can be programmed by setting the Level and Time parameters of
the envelope segments.
Note-on
Note-off
Attack
Time
Decay
Time
Release Time
Attack Level
Sustain
Level
Time
Break Point
Start
Level
Slope
Time
Amplifier EG
Volume
▪ Use the Level parameters (-99…+99) to specify the volume level that will be
reached at the end of the segment.
EG Level Meaning
Start Volume level at note-on. If you want the note to begin at a loud level,
set this to a high value.
Attack Volume level that will be reached after the attack time has elapsed.
Break (Break Point) Volume level that will be reached after the decay time has elapsed.
Sustain Volume level that will be maintained from after the slope time has
elapsed until note-off occur.