KORG PA4X 76 - Manual (Page 505)

Effect parameters |501
e EQ Trim 0…100 Sets the EQ input level
f Pre LEQ Fc Low,
Mid-Low
Selects the cutoff frequency (low or mid-
low) of the low-range equalizer
Pre HEQ Fc High,
Mid-High Selects the cutoff frequency (high or mid-
high) of the high-range equalizer
g Pre LEQ Gain [dB] –15.0…+15.0 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15.0…+15.0 Sets the gain of High EQ
h Wet/Dry Dry, 1:99…99:1,
Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
c: ER Level
d: Reverb Level
These parameters set the early reflection level and reverb level.
Changing these parameter values allows you to simulate the type of walls
in the room. That is, a larger “ER Level” simulates a hard wall, and a larger
“Reverb Level” simulates a soft wall.
Reverb - Room Type
Time
Level
Louder
ER
(Early Reflections)
Dry
Reverb
Pre Delay Thru
Pre Delay Reverb Time