KORG PA4X 76 - Manual (Page 599)

Effect parameters |595
f: Trigger Monitor
Setting this parameter On will cause the trigger signal to be output, instead
of the effect sound. Use this parameter to check the trigger signal with EQ
applied.
Usually, set this to Off.
f: Side PEQ Insert
g: Side PEQ Cutoff [Hz]
g: Q
g: Gain [dB]
These parameters are used to set the EQ applied to the trigger signal.
The Limiter determines whether the compression is applied or not, based on
the post-EQ trigger signal. Setting the equalizer allows you to set the Limiter
to respond to any frequency band.
Multiband Limiter
This effect applies the Limiter to the low range, mid range, and high range
of the input signal. You can control dynamics for each range to adjust the
sound pressure of the low range, mid range, and high range in a different
way from the EQ.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Gain Adjust
Mid Offset
Low Offset
High Offset
Envelope - Control
Envelope - Control
Envelope - Control
Low
Mid
High
Band-Pass Filters
+
Limiter
Limiter
Limiter
a Ratio 1.0 : 1…50.0 : 1,
Inf : 1
Sets the signal compression ratio
b Threshold [dB] –40…0 Sets the level above which the compres-
sor is applied
c Attack 1…100 Sets the attack time
d Release 1…100 Sets the release time
e Low Offset [dB] –40…0 Gain of the low-range trigger signal
f Mid Offset [dB] –40…0 Gain of the mid-range trigger signal